You are here: Develop Mode > Tuning Images > Adding a Post-Crop Vignette

Adding a Post-Crop Vignette

Use the Post-Crop Vignette effect to add a frame around a subject. You can also control the appearance of the border. Use the Post-Crop Vignette as a finishing tool after an image is cropped. This gives you more control over the focal point of the image.

You can save your settings as a preset for future use.

To Apply a Vignette Effect:

In Develop mode, select the Tune tab.
In the Post-Crop Vignette group, make adjustments as described below.

You can right-click a slider to reset to the default value.

Vignette Options

Strength	Drag the slider to the right to add a white vignette, or drag to the left to add a black vignette.
Radius	Adjusts the distance from the corners of the image where the pixels will be softened. The higher the radius, the further from the center the pixels will be before the softening begins.
Feathering	Feathering controls how soft or hard the edge of the vignette is. Drag the slider to the right to increase the softness of the vignette transition.
Roundness	Drag the slider to the right to increase the roundness of the vignette, or to the left to make it more rectangular.